我們都知道濟南電纜橋架要用薄鋼板沖壓成的。其負載水平大小是一個與橋架規格和支撐間距相關的量。對應著同一支撐點位置和彎凸變形程度，側邊相對高度大一點的電纜橋架承載力大，相對高度小一點電纜橋架承載力小。

　　We all know that the cable tray in Jinan is made of sheet steel. The magnitude of its load level is a quantity related to the specifications of the bridge and the spacing between supports. Corresponding to the position of the same support point and the degree of bending deformation, the cable tray with a larger relative height on the side has a larger bearing capacity, while the cable tray with a smaller relative height has a smaller bearing capacity.

　　一般情況下電纜橋架每過1.5～2.0m組裝一組固定支架。

　　電纜線電纜橋架的具體承載力量計算G總=a1*b1+a2*b2……aa*ab公式計算，ab分別代表每條電纜線單位重量(kg/m)和電纜數量。

　　Generally, a group of fixed supports shall be assembled every 1.5~2.0m for cable tray.

　　The specific bearing capacity of the cable cable tray is calculated by the formula G=a1 * b1+a2 * b2...... Aa * ab, where ab represents the unit weight (kg/m) and number of cables of each cable.

　　因為電線電纜在電纜橋架內一般是單面水準排出，因此其安裝橋架總寬S為：S=a1*(a1+b1)+d2*(a2+b2)+……ad*(an+bn)公式計算中

　　分別代表電纜橋架內各種各樣電纜直徑，單位是mm;相同產品規格電纜數量;電纜線擺放后的間隔，該值應該不小于電纜直徑的1/4。

　　Because the wires and cables are generally discharged horizontally on one side in the cable tray, the total width S of the installed cable tray is: S=a1 * (a1+b1)+d2 * (a2+b2)+...... Ad * (an+bn) in the formula calculation

　　Represent various cable diameters in cable tray, in mm; Number of cables of the same product specification; The interval between cable placement should not be less than 1/4 of the cable diameter.

　　總之，濟南電纜橋架是一款為保護電纜而衍生的產品，是電纜的保護殼，防止電纜受到外界因素的損壞，主要由支架、托臂和安裝附件組成，歡迎大家前來咨詢了解。

相關文章：濟南電纜橋架